ESpring Water Purifier Owner's Manual download pdf (Page 11)

Fig. 33A

Fig. 36

Fig. 34

Fig. 35

Fig. 37

Fig. 38

Fig. 39

Fig. 33B

Fig. 41

Fig. 42

Fig. 40

CARTRIDGE REPLACEMENT

(10-0186)

Refer to the exploded view of the

eSpring

Water Puriﬁer for assistance

with part names (See inside front cover).

1. Unplug the Power Adapter from

the wall outlet.

2. Turn off water to Water Puriﬁer.

a) If using the Diverter, turn off

the kitchen faucet and place the

Water Puriﬁer in the sink. Pull the metal pin on the Diverter to

drain water (Fig. 33A).

b) If using the Auxiliary Faucet, turn off the cold water supply using the shut-

off valve . Turn on Faucet to drain water and leave open . Place

towels around the Base of the Water Puriﬁer (Fig. 33B).

3. Remove the Top Shroud

. Remove

the Electronic Module . Then,

remove the tubing removal tool

(Fig. 34).

Draw a line with an ink pen across the

top of each tube where it meets the

rings on the Water Puriﬁer (Fig. 35).

5. Make sure the logo on the removal tool is facing out and the tool is ﬂat

against the Bracket. Firmly push

the tool against the rings with your

ﬁngers and then pull the tubes out

with the opposite hand while rings

are depressed (Fig. 36).

NOTE: If you do not have the Removal

Tool, remove each tube by pressing evenly

with your ﬁngertips on both sides of the

rings that surround the tubing. Then, pull

the tube out with the opposite hand.

6. Unscrew to remove the Retaining Ring (Fig. 37).

7. Lift the handle on the Bracket. Pull

straight up to remove the attached used

Cartridge and Bracket (Fig. 38).

8. Unscrew Cartridge from Bracket to

remove and dispose of the Cartridge in

accordance with local requirements

(Fig. 39).

NOTE: The UV lamp in the Cartridge contains

mercury. Please dispose of according to local,

state or federal laws.

9. Empty water from the Base. Then,

inspect seal and upper interior surface of

Base and remove any dirt (Fig. 40).

NOTE: DO NOT allow vegetable oil, petroleum

jelly, or other lubricants, solvents, ammonia,

alcohols, acids, or strong cleaning solutions to

come into contact with the Water Puriﬁer. They

could cause permanent damage to the Base. Use

food grade silicone (WTI-0895) on o-rings to

lubricate if needed. When cleaning, use a mild

liquid dishwashing detergent and water.

10. Remove the protective plastic wrap from

the new eSpring Cartridge (10-0186).

11.

Firmly press Cartridge and Bracket to-

gether . Screw the Cartridge onto the

Bracket until it comes to a STOP (Fig.

41).

12. Reinsert the Bracket (with the attached

Cartridge) into the base by aligning the

notches of the Bracket with the tabs on

the Base . With the handle down,

ﬁrmly push down on the Bracket until it

contacts the Base (Fig. 42).

1035793_eng.indd 9 6/10/14 4:42 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comments to this Manuals

No comments

ESpring Water Purifier Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Water dispensers ESpring Water Purifier